The rest of the P2B-LS's features look much like many other boards from the 440BX garden, here's the official black and white onit:
Processor
Single Slot 1 for Intel® Pentium® II Processor (233MHz-500MHz)
Chipset
Intel® 100 MHz 440BX AGPset with PIIX4E South Bridge
Bus Architecture
32-bit PCI Bus, 32-bit AGP Bus and 16-bit ISA Bus Compatible
Expansion Slots
1 x 32-bit AGP Slot
4 x 32-bit PCI Slots (PCI Rev 2.1 Interface Compliant)
2 x 16-bit ISA Slots
Cache
Processor Built-In 512KB Level 2 Cache
System Memory
4 x 168-pin DIMM Sockets to Support 8MB to 1024MB SDRAM Utilizes 4/8/16/32/64/128/256MB 168-Pin DIMM 3.3V SDRAM Features ECC Support PC100 (100MHz)Compliant SDRAM Interface
Onboard I/O
1 x Floppy Port (Up to 2.88MB, 3 Mode)
2 x Serial Ports (16550 Fast UART Compatible)
1 x Parallel Port (EPP, ECP Port)
1 x RJ45 (DK440LX I/O Shield) IrDA TX/RX Header (Optional)
Onboard PCI IDE
Dual UltraDMA/33 IDE Ports Support Greater than 8.4GB HDD, ATAPI IDE CD-ROM & LS-120
AGP Slot
AGP 66MHz/133MHz (Sideband) 3.3V
Device ATX Double Decker
2 x USB Ports
1 x PS/2 KeyBoard Port
1 x PS/2 Mouse Port
1 x Parallel Port
2 x Serial Ports
1 x RJ45
(DK440LX I/O Shield)
ATX Power Conn.
3V, 5V and 12V 20-pin ATX Power Connector. Soft Power Support
BIOS
2M-bit Flash EPROM
Award® Anti-Boot Virus & PnP BIOS with ACPI, AGP, DMI, Green, Plug and Play Features
Enhanced ACPI Features for PC98/Win98 Compliance Adaptec ® Ultra2 SCSI
Ultra2 SCSI Onboard
Adaptec ® AIC 7890 & 3860 80MB/s Ultra2 Wide SCSI Onboard (AIC 3860 Optional)
Other Features
Intel 82558 100/10Mbps LAN Onboard Onboard Creative® SB-Link Header CPU & Power Supply Temperature Headers Chassis Intrusion Heater SM Bus Header USB Ports
Dimensions
ATX Form Factor (10.55" x 12")
Let's take a look at some of the specs above…..
First, the size of this board is immense. It makes Abit's large BX6 mainboard look like a post-it note. We're talking dimensions of 10.5" x 12" here, buyers should be warned that some of the less expensive cases that skimp on the true ATX form factor spec may give some trouble when trying to mount the P2B-LS. For Sharky Extreme, the P2B-LS mounted fine in both a mid-tower and full tower, but it was a little close in the mid-tower….this baby is that big…..
